P2177 TOO LEAN OFF IDLE P2187 TOO LEAN AT IDLE P0138 O2 CIRCUIT HIGH VOLTAGE
Diagnose engine misfire
INTAKE MANIFOLD – Remove & Replace
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( %) Rear ( %)
Replace front brake pad linings and machine front brake disc rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Road test vehicle.
MARIA H. gave our service a 5 star review on 2/15/2023
Replace front brake pad linings and machine front brake disc rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Road test vehicle.
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( %) Rear ( %)
Rear Ceramic Brakes
JERRY S. gave our service a 5 star review on 2/9/2023
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
Brian H. gave our service a 5 star review on 2/6/2023
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( %) Rear ( %)
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
TIE ROD &/OR END – Remove & Replace – Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
Test drive to locate area of sound and inspect vehicle
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Right Side – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
CONTROL ARM – Remove & Replace – V6 Lower,One Side,w/o Engine Removal – [DOES NOT include alignment.]
CONTROL ARM – Remove & Replace – V6 Lower,One Side,w/o Engine Removal – [DOES NOT include alignment.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
3K Service
Doc J. gave our service a 5 star review on 1/27/2023
POWER STEERING HOSE – Remove & Replace – V6,3.8L Eng One,Pressure Line – [Includes: Bleed Power Steering System.]
RETURN HOSE CLAMP
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
MYRA K. gave our service a 5 star review on 1/26/2023