Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front (5MM) Rear (5MM)
DANIEL W. gave our service a 5 star review on 10/30/2024
Replace front brake pad linings and machine front brake disc rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Road test vehicle.
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( %) Rear ( %)
KATIE D. gave our service a 5 star review on 10/11/2024
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – V6 One Side – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
BALL JOINT – Remove & Replace – Lower,One Side – [DOES NOT include alignment.]
BALL JOINT – Remove & Replace – Upper,One Side – [DOES NOT include alignment.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
TIE ROD &/OR END – Remove & Replace – Outer,One Side – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models
Randy T. gave our service a 5 star review on 10/6/2020